This is a simple and useful pattern for creating edge effects and curvature based results like wear on edges and objects in contact with other surfaces.

Parameters

Num Samples

Controls the number of samples used to calculate curvature per camera hit point. More samples reduces can reduce the noise at the cost of increased render time.

Sample Distribution

Max Distance

Samples travel a certain distance before being terminated. Lower values tend to generate sharper changes while larger ones spread out the effect and may lose details. Other objects may occlude as your distance becomes higher. Interiors are the most obvious way to see this effect. 0.0 means "infinite", or essentially your scene extentPossible values are uniform and cosine (Lambertian).

Trace Set

You may use Trace Sets to include other objects from the rays being traced. Helpful when you need a large Max Distance but don't want other objects occluding the result. Note this is not an exclusion, it's inclusion of the specified set.

Sample Distribution

Possible values are, in order, uniform and cosine (Lambertian).

Image AddedImage Added

Cosine Spread

Sample spread of rays when using cosine distribution. A value of 1.0 gives a perfect Lambertian distribution.

Lower values shrink or "tighten" the effect along curves while larger amounts spread out the effect.

Bias

The bias will affect the falloff of the curvature and will always be linear, decreasing with the distance from the shaded point to the sampled point. Bias can be used to take further samples into account more or less while nearby points have more weight.

• The closer to 0.0, only points closest to the shading point will contribute.
  
• With the default of 0.5 any points close to Max Distance will contribute less, and points close to the shaded point will contribute more. 
• The closer to 1.0, the more all sampled points will contribute. At exactly 1.0 sampled points at all distances will contribute equally.

Max Distance

The max distance at which objects may occlude. Zero is infinite (all objects occlude), this may not be desirable in enclosed or interior spaces.

Convex Threshold

Increasing this parameter erodes the result, shrinking the visible effect.

Concave Threshold

Increasing this parameter erodes the result, shrinking the visible effect.

Output

Output Gain

A multiplier for the resulting curvature effect (areas without curvature are naturally unaffected)

Output Output Type

Set to "Concave", only concave curvature will be output. Set to "Convex", only convex curvature will be output. "Both" will show both convex and concave curvature.

Trace Set

Monochrome Output

The result is a simple white or greyscale value for both concave and convex results. Off outputs Convex as Red and Concave as Green

Image Added

Clamp Output

Values are clamped to 0-1 ranges by default. If you require an expanded range (perhaps with the gain control or to drive another parameter connection) you can disable thisAssigning a trace set will mean curvature will only be tested against objects within that trace set.