This is RenderMan 21 Documentation you are viewing. The Rmanwiki home page will redirect you to the current documentation.
This infinite light simulates a bright distant light source like from the sun or moon. This light bathes the entire scene and treats the light as-if the rays are parallel by default (this can be altered in the settings below).
Only rotation (direction) will be applied. Translation and scaling of this light will be ignored.
IntensityScales the contribution of this light linearly.The light intensity is computed using physical units which are typically 100 times too intense for regular RGB rendering. We scale it internally by 1e-e5 to generate pleasing illumination levels.
Specifies the exposure of the area light as a power of 2. Increasing the exposure by 1 will double the energy emitted by the light source. A value of 0 produces an intensity of 1 at the source, -1 produces 0.5.
Opening angle of the light source in degrees (Sun=0.53).
Distance of the light.
The color of the emitted light. If a color map is specified, this tints the color map.
Turns color temperature on or off.
Allow the user to choose the color temperature of the light in Kelvins. Unlike the basic light color, this allows the user to easily pick plausible light colors based on standard temperature measurements.This control will act like a filter or gel (a tinted transparent surface) in front of your light. If your light is white, you will get the chosen color temperature. If your light is colored, the color temperature will make it cooler (over 6500K) or warmer (below 6500K).
NOTE: The effect will be less pronounced on fully saturated mono-chromatic lights. Defaults to 6500K, which should be very close to white on most monitors (D65 illuminant used by sRGB and Rec 709).
Off-axis cosine power exponent to shape the emission. This controls the spread of the light. Higher numbers will start focusing the light towards the center and thus narrowing the light spread.
Emission Focus Tint
Off-axis light color tint. This tints the emission in the falloff region starting from the off-angle direction of the light towards the center. By default, the tint color is black (none). In addition to tinting, values greater than white will also increase the intensity of the falloff region.
Amount of specular light that is emitted. This is a non-physical control.
Amount of diffuse light that is emitted. This is a non-physical control.
Note: All shadow parameters will be ignored if the light's bidirectional is enabled.
Enable raytraced shadows.
The color of the shadows cast by emitted light. This is a non-physical control.
.0 0.0 0.0
The maximum distance of the shadow starting from the position of the point being shaded. -1.0 is unset which will use the distance between the point being shaded and the point on the light.
The distance from the light at which shadow falloff begins. -1.0 turns off shadow falloff.
Shadow Falloff Gamma
The gamma of the shadow strength in the falloff zone.
Set of geometry to consider for traced shadow intersection. If this is not specified, all geometry are considered for traced shadow intersection.
Don't Trace Subset
Set of geometry to ignore for traced shadow intersection. If this is not specified, no geometry is ignored for traced shadow intersection.
Trace Light Paths
Enable light and photon tracing from this light.
Enable thin shadow (fake colored shadows for transparent objects) and disable refraction caustics for this light. This parameter will be ignored if Trace Light Paths is enabled.
Specifies an override of the number of light samples to be taken for this light source. If set to something other than zero, it will override the sampling performed by the integrator. You might find need for this if you have unsolvable noise from this light and need mroe samples.
Specify the light group name used for light group LPEs. This is useful to generate per-light AOVs for later adjustment in compositing.