...
In Auto mode, Fresnel Blend will be used when the base layer is diffuse, while Rough Coating will be used when the base layer is specular.
Layering Modes
Fresnel Blend
Section | |||||||
---|---|---|---|---|---|---|---|
|
Rough gold base layer and dielectric top layer with varying IOR (1.0-3.0) |
Rough Coating
Section | |||||||
---|---|---|---|---|---|---|---|
|
Rough gold base layer and dielectric top layer with varying IOR (1.0-3.0) |
Attenuation
LamaDielectric (absorptionColor set to red) layered on top of a white LamaDiffuse, layer thickness varying from 1 to 3.2 |
The top layer is considered for both the outgoing and incoming rays, meaning that the ray is attenuated by the top layer twice: once when it leaves and once when it exits. This is the case for both fresnel attenuation at the interface, and for absorption through the thickness of the layer.
Refraction
Refraction is considered by refracting both the incoming and outgoing rays through the top layer, instead of passing them straight through as in the fresnel blend mode. This changes the look of the base layer as it receives these refracted rays. As an approximation, the top layer is considered to have a roughness of zero for the refraction calculation. This means that as the roughness of the top layer increases, the accuracy of the model decreases.
Scattering
To compensate for rough top layers, the roughness of the base layer is clamped to the roughness of the top layer, so that if the roughness of the top layer is greater, then the roughness of the base layer will be increased to match it. This approximates the scattering of rays as they pass through the rough top layer.
Relative IOR
The IOR of the top layer is also tracked, so that the relative IOR of the base layer is correct. For example, if there is a water layer on top of a skin layer, the relative IOR of the skin layer will be reduced, causing lower reflectivity.
Smooth Coating
The smooth coating layer mode is very similar to the rough coating mode, but without the roughness clamping. This allows for greater control of the base layer roughness.
Auto
The auto mode is identical to rough coating in most cases, but switches to fresnel blend for diffuse layers. This is to accommodate for the common Diffuse < Specular < Clearcoat material configuration, where the diffuse and specular materials are thought of as one single base material, with the clearcoat sitting on top.
...